Thread: Gas Strut Assembly End Fixtures
View Single Post
  #2   Spotlight this post!  
Unread 24-06-2002, 00:24
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
sounds like a mistake...
Posted by Joe Johnson.   [PICTURE: SAME | NEW | HELP]


Engineer on team #47, Chief Delphi, from Pontiac Central High School and Delphi Automotive Systems.

Posted on 11/9/2000 8:53 PM MST


In Reply to: Gas Strut Assembly End Fixtures posted by Janna on 11/9/2000 5:40 PM MST:



Janna,

The struts should have identical end fittings. The large and the small have different brackets, but the same on both ends of the same strut.

Contact Martus for exchanges (mmartus@home.com)

Joe J.



__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.