Thread: Rubber Treads Anyone?
View Single Post
  #1   Spotlight this post!  
Unread 24-06-2002, 00:29
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Re: Rough-top conveyor belting
Posted by Raul.   [PICTURE: SAME | NEW | HELP]


Engineer on team #111, Wildstang, from Rolling Meadows & Wheeling HS and Motorola.

Posted on 11/29/2000 3:45 PM MST


In Reply to: Rough-top conveyor belting posted by Allen Smith on 11/29/2000 1:44 PM MST:



Allen,

Thank you. I also found it in the MC catalog a day after I wrote the post. We will try it out.
Who is MSC?

Raul

: This belting grips the carpet very well and is available from McMaster-Carr or from my new favorite supplier MSC. We turned the peak off our wheels so we had a flat section to attach to, then glued and screwed the belting to the wheel. This worked well but may have given us too much traction and exposed weaknesses in the drive train. I would use it again



__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.