Thread: New Improved DrJoesDrillShaft
View Single Post
  #1   Spotlight this post!  
Unread 24-06-2002, 00:34
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
I have a source...
Posted by Joe Johnson.   [PICTURE: SAME | NEW | HELP]


Engineer on team #47, Chief Delphi, from Pontiac Central High School and Delphi Automotive Systems.

Posted on 12/4/2000 8:20 PM MST


In Reply to: Shaft Rules posted by Dodd Stacy on 12/4/2000 4:33 PM MST:



Dodd,

Due to a bad decision (that was mostly due to yours truly) with regard to our OCCRA robotic league, we had about a dozen robots driving in circles at our first OCCRA regional!

I quickly worked to cover my tracks! Basically, I had to have 32 of these drill shafts FAST. As a result, I had to find a source to make them quickly. I found a local source to make them for $75 each, not the cheapest I am sure but they were to print and on time (2 days from print to parts).

I suppose that I could set them up to do it all over again if enough teams want them.

As to whether it is 'legal' or not, I suppose that it IS legal if the material is from Small Parts.

Other thoughts?

Joe J.


__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.