|
Re: pic: 1565 Linkage Troubles
I would defiantly recommend getting some sort of bend in that flat bar, or replacing it with angle if you do this drive in the future. With the angle you could mill down one of the sides down to like 1/4" so it wouldn't take up as much space, but shouldn't bend like flat bar will.
__________________
Co-Founder of Taplytics.com
2013 World Champions (1241, 1477, 610)
Crescent Robotics Team 610 Mentor
K-Botics Team 2809 Founding Mentor ('09-'11)
Queen's University Mechanical Engineering, Applied Science '11
Crescent Robotics Team 610 Alumni
|