Thread: Building the kitbot frame- mate the holes?
View Single Post
  #4   Spotlight this post!  
Unread 10-05-2008, 20:56
Bryan Herbst's Avatar
Bryan Herbst Bryan Herbst is offline
Registered User
AKA: Bryan
FRC #2052 (KnightKrawler)
Team Role: Mentor
  
Join Date: Sep 2007
Rookie Year: 2007
Location: Minneapolis, Minnesota
Posts: 544
Bryan Herbst has a reputation beyond reputeBryan Herbst has a reputation beyond reputeBryan Herbst has a reputation beyond reputeBryan Herbst has a reputation beyond reputeBryan Herbst has a reputation beyond reputeBryan Herbst has a reputation beyond reputeBryan Herbst has a reputation beyond reputeBryan Herbst has a reputation beyond reputeBryan Herbst has a reputation beyond reputeBryan Herbst has a reputation beyond reputeBryan Herbst has a reputation beyond repute
Re: Building the kitbot frame- mate the holes?
All the parts are mated great now!

I've been playing with the smart fasteners tool, but I can't figure out how to get it to fasten only one set of two holes. Whenever I select a hole to fasten, it makes one really long fastener that goes through all the holes that line up with that hole. For example- in trying to fasten the end cap to the top of the rail, it makes one bolt that goes through the end cap, then the rail, then the other side of the rail, then the other side of the endcap. How can I go through just the first two?


EDIT: Scratch that, found the split feature.
__________________
Team 2052- Knightkrawler
Mentor and volunteer
Last edited by Bryan Herbst : 10-05-2008 at 21:33.
Reply With Quote