View Single Post
  #1   Spotlight this post!  
Unread 23-06-2002, 22:05
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
 
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
MasterCam Posting

Posted by Steve Prairie at 12/19/2000 10:13 AM EST


Student on team #173, RAGE, from Rockville High School /East Hartford High School and UTRC.



Has anyone had experience posting Mastercam v8 to Light or Dyna milling machines? If so, can I contact you about some questions and problems I have?

Thanks

Steve Prairie
RAGE #173


__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.