Thread: size of see saw?
View Single Post
  #2   Spotlight this post!  
Unread 23-06-2002, 22:28
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Re: size of see saw?
Posted by Matt Berube at 1/7/2001 5:48 PM EST


Engineer on team #49, Delphi Knights, from Buena Vista High School and Delphi Automotive.


In Reply to: size of see saw?
Posted by nick237 on 1/7/2001 5:15 PM EST:



: The sizes of 8' x 4' for the see saw ramp is on the drawing but the hight is not. there is 2" angle 6" apart but no sizes for the hight from the floor to the top flat surface of the ramp carpet when level.
: can anyone help??? and where did you see the answer.
: nick237

I figure it is a little more than 13 in.

(2 X 8, 3/4 plywood, angle iron, 4 in. of rail under)

What do the rest of you think/

I also hope we get some more details.

Matt T49


__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.