Thread: Fastest way to lower the bridge?
View Single Post
  #9   Spotlight this post!  
Unread 23-06-2002, 22:32
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Re: Fastest way to lower the bridge?
Posted by Deej at 1/9/2001 5:12 PM EST


Engineer on team #190, Gompeii, from Mass Academy and WPI.


In Reply to: Fastest way to lower the bridge?
Posted by Raul on 1/8/2001 8:16 AM EST:



Why not just be the last robot across the bridge by helping out.... What I mean is be the robot on the starting side that lowers the bridge after a robot as toggled it. THat way there you don't have to worry about lifting from the other side. Just a thought


: What does everyone think here. Just a couple of my thoughts:

: If you are on the side with the bridge up, just push down on it; this is obvious enough.

: If you just went over the bridge and want to reset it for others to come over - just drive next to the bridge and push on the pole holding the weights. Any other scheme of trying to grab it or scoop under it is likely to take longer.

: Raul





__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.