Thread: I got answers from FIRST (Eric)
View Single Post
  #14   Spotlight this post!  
Unread 23-06-2002, 22:33
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
I got answers from FIRST (Ron) - PVC and Weight Supports
Posted by Mark Pierce at 1/9/2001 12:04 PM EST


Other on team #288, RoboDAWGS, from Grandville High School and X-Rite, Delphi, and others.


In Reply to: I got answers from FIRST (Eric)
Posted by Raul on 1/8/2001 12:56 PM EST:



Here are some question and answers I got from Ron:

>1. The quantity of PVC1 should be 16 per goal. (8 sides, 2 pcs on either side of the tee).

1. Yes there should be 16.

>2. The Bill of material for WT1 says 10 - 3 pounds weights, but the pictures from the kickoff look like 6 weights on a side. Are these 12 - 2.5 lb weights?


2. There are actually 12 weights total and they are 3 pound Weider cast
iron weights.

>3. The pipes listed as P12, P13, P14 Are used to hold the weights, but how are they assembled? The drawings do not help much on this.

3. The 1" pipe is inserted flush in the 1-1/4" pipe and the 3/4" pipe is a
tight fit in the 1" pipe.

It looks to me like the length of PVC1 might be wrong also, when comparing to pictures. Anyone have a measurement? ( I submitted a question in my reply to Ron, but I'm sure he's swamped.....)

Mark

__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.