Thread: Blue Prints
View Single Post
  #3   Spotlight this post!  
Unread 23-06-2002, 22:33
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Um, still a few mistakes.
Posted by Peter VanWylen at 1/8/2001 9:23 PM EST


Student on team #107, Team ROBOTICS, from Holland Christian High School and Metal Flow Corporation.


In Reply to: Much Better!
Posted by Peter VanWylen on 1/8/2001 8:37 PM EST:



Oops. I spoke too soon. I just found a mistake on the latest drawing/field BOM. There are two P16 pipes, both made out of different material, and of different sizes. One goes on the stretcher, and one is on the center barrier. One of these needs to be renamed as P18. Anyways, besides this little identity crisis, the P16 for the center barrier is of size 14.25". It would seem that this P16-centerbarrier should be of the same size as P8, right? P8, however is of size 16". Needless to say, its not time to start building your field yet.

Am I missing something here? Maybe so. Please tell if you see what I see.


__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.