Thread: Rev. 2 Blueprint corrections
View Single Post
  #3   Spotlight this post!  
Unread 23-06-2002, 22:36
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Don't build that field quite yet...
Posted by Peter VanWylen at 1/9/2001 8:50 PM EST


Student on team #107, Team ROBOTICS, from Holland Christian High School and Metal Flow Corporation.


In Reply to: Re: Rev. 2 Blueprint corrections
Posted by Paul on 1/9/2001 4:13 PM EST:



Hmm. Can't answer your question, but I share your frustration. My suggestion to teams is that you start strategizing, not builiding fields, because the blueprints are far from perfect as it is. I suppose that the outside border is pretty much settled (if you have questions, just download last year's diagram which was properly dimensioned) so you could start on that.

Here is my newest list of field problems:

It appears from the blueprint that there should be 2 P10s. The BOM has 4.

It appears from the bluepring that there should be 4 R1s. The BOM has 5.


If somebody has time on wednesday, while I am in school, it would be good to call FIRST on these ones and Paul's question. Please post an answer here.



__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.