Thread: high-low gear switching
View Single Post
  #8   Spotlight this post!  
Unread 23-06-2002, 22:39
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
oops...
Posted by Ken Leung at 1/13/2001 2:19 PM EST


Student on team #192, Gunn Robotics Team, from Henry M. Gunn Senior High School.


In Reply to: Huh?
Posted by Andy Baker on 1/13/2001 6:26 AM EST:



You are right, Andy. It just seems like the motor is hanging outside of the whole setup without support at the back... it was late at night and I wasn't thinking clearly. But one thing worth adding to the back of the motors are stree relieve to the wire tab at the back of the motor. We learn this lesson the hard way at competition. The tab broke off because of some reason, and we had to rush to replace the motors with new one's, but we forgot to call a time out. That cost us the regional. And this year there aren't even time out.

But hey! Thanks for sharing this setup with everyone out here. It's an amazing design! How did you manage to create this out of nowhere?


__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.