Quote:
Originally Posted by Don Rotolo
Rinse again with distilled water, dry with paper towels and Q-tips (focus on the connectors and under components) and put it into a warm (150-200F, no more) oven to dry for an hour.
Don
|
If you choose this method, you can use your kitchen oven set at the lowest temperature possible. Crumple up some aluminum foil to hold the component above the oven rack. (only small bits of the aluminum will be in contact with the component so that the rack doesn't melt into the plastic housing) Leave the oven door cracked open while the component is inside. Most oven doors have a detent to keep the door open a few inches. Above all, don't go take a nap! Watch the piece frequently during the drying period. I leave the piece inside the oven and then turn it off. That way the cool down cycle is very slow. You can nap during this part. This technique has worked well for electronics dropped into lakes and rivers and toilets or left out in the rain. It may not fix a multielement lens with water between the elements but I have revived several cameras dropped into sinks at concerts or left on the top of a car during a rainstorm.