Thread: Anyone going under the rail?
View Single Post
  #9   Spotlight this post!  
Unread 23-06-2002, 22:41
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
12 inches ??
Posted by Justin Ridley at 1/12/2001 1:17 AM EST


Engineer on team #221, MI Roboworks, from Michigan Technological University.


In Reply to: Limbo-bot?
Posted by Raul on 1/10/2001 11:10 PM EST:



Where are we getting the 12" figure from between the bar and the 4x6. It seemed to me it would be a few inches bigger. Does anyone have an accurate measurment from a center rail with correct key clamp flanges? If so I would appreciate a post of that number.

Thanks,

Justin Ridley - MI Roboworks


PS: We're gonna do it, 12" inches or not


__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.