Thread: How much force to push the ramp?
View Single Post
  #2   Spotlight this post!  
Unread 23-06-2002, 22:44
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Could be a LOT!
Posted by Ed at 1/11/2001 8:28 PM EST


Coach on team #34, DaimlerChrysler/ Bob Jones High , from Bob Jones High / New Century High and DaimlerChrysler/Bob Jones High/ New Century High.


In Reply to: How much force to push the ramp?
Posted by colleen -- T190 on 1/11/2001 7:51 PM EST:



I attended the kickoff and found the amount of force required to "switch" the position of the unloaded bridge to be relitively minor compared to the possibility of the force required if another robot is on the far end, especially if I'm not applying the force at the very end of the bridge. It could be 130 lbs or more ! Yikes !


__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.