Thread: Goal Construction
View Single Post
  #2   Spotlight this post!  
Unread 23-06-2002, 22:48
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Re: Goal Construction
Posted by Rob Gordon at 1/12/2001 1:07 PM EST


Engineer on team #69, H.Y.P.E.R., from Quincy Public Schools and The Gillette Co..


In Reply to: Goal Construction
Posted by Gary Bonner on 1/12/2001 11:55 AM EST:



It looks like the 12.5" radius is to the center of the flanges. But it isn't 100% clear.

The quickest source for the Al pipe is McMaster-Carr. They take credit card orders, and you will have it in one day (most of the time). They are not cheap though. Their web site is http://www.mcmaster.com/

Good luck,
Rob

: The plans indicate a radius of 12.5 inches for the flange bases on the goal. Is that to the center or edge of the flange?

: What’s a good source for the schedule 40 Al pipe?

: Thanks





__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.