Thread: Goal Building
View Single Post
  #1   Spotlight this post!  
Unread 23-06-2002, 22:51
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Goal Building
Posted by Charlie at 1/13/2001 11:15 AM EST


Student on team #222, Tigertrons, from Tunkhannock Area High School and P&G - Ronco Machine - NEPATPC.



1)What is the length of the bottom horizontial edge of the DP2? 2)When constructing the bridge, what distance does F1(lip on bridge) over lap the R2(plywood)? 3)When cutting the DP2, what are the angle cuts on the ends of each side of the plate?

Thanks,
Charlie



__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.