Thread: Pneumatic help
View Single Post
  #3   Spotlight this post!  
Unread 23-06-2002, 22:53
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Re: Make the display board...
Posted by Josh Vetter at 1/13/2001 10:50 PM EST


Student on team #548, Robostangs, from Northville High School and BOSCH.


In Reply to: Make the display board...
Posted by Joe Johnson on 1/13/2001 10:24 PM EST:



Thats what we started to do. The picture isn't very clear, but I think we have it hooked up right. Is there a way to operate the solenoid valves without using the robot controller? We got most of the pneumatic setup done, but the rest is not ready yet, and we want to test the pneumatics, and start working with them.
Thanks
Josh

: I recommend that you make a display board similar to
: the one shown in the flyer that came with the kit.

: This will show you how you have to plumb these things
: to make them work.

: Chief Delphi 6 will definitely use pneumatics this
: year. This is a milestone of sorts because we have
: barely given them a second look since our rookie year
: when they let us down and we had to do a major redesign
: to get our robot even to function. This year they look
: very good, very good indeed.

: Joe J.





__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.