Thread: Pneumatic help
View Single Post
  #5   Spotlight this post!  
Unread 23-06-2002, 22:53
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Manually operating the valves & FORCE!
Posted by Andy Baker at 1/14/2001 8:45 AM EST


Engineer on team #45, TechnoKats, from Kokomo High School and Delphi Automotive Systems.


In Reply to: Re: Make the display board...
Posted by Josh Vetter on 1/13/2001 10:50 PM EST:



You can manually operate the valves by pressing the red (or orange) button on the valve. This helps when debugging and hand-operating the valves.

As for the pneumatics in general... think of the force involved:

F=PA

The force of a 2" cylinder = the pressure (60 psi) x the area of the cylinder (3.14 sq.in.).

That's over 180 lbs. of force... yowee.

Andy B.

ps... we will surely be using pneumatics



__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.