Thread: Goal pipe spacing too narrow to push balls through???
View Single Post
  #2   Spotlight this post!  
Unread 23-06-2002, 22:53
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Re: Goal pipe spacing too narrow to push balls through???
Posted by Tim Baird at 1/14/2001 12:28 AM EST


Engineer on team #190, Gompei, from Massachusetts Academy of Math and Science and WPI.


In Reply to: Goal pipe spacing too narrow to push balls through???
Posted by Rob DeCotiis on 1/13/2001 11:19 PM EST:



We built the goal to the exact size and we were able to push a ball through by just pulling the two bars apart a little bit. It may not be easy, but very possible.
Tim

: Hey, My school built the goal exactly to size and we noticed that we couldn't push the balls through the sides. Has anyone else seen this? i see they show in the manual "The Game" a robot pushing a ball through the sides. has anyone done this?


__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.