Thread: Goal pipe spacing too narrow to push balls through???
View Single Post
  #7   Spotlight this post!  
Unread 23-06-2002, 22:53
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Re: clock is ticking
Posted by Ken Leung at 1/14/2001 5:45 PM EST


Student on team #192, Gunn Robotics Team, from Henry M. Gunn Senior High School.


In Reply to: Re: Goal pipe spacing too narrow to push balls through???
Posted by Michael Martus on 1/14/2001 1:06 PM EST:



I agree... more multiplier is much better couple more of black balls in the goal. And keep in mind, the balls are never inflated to the exact size. So you will need to build a flexible balls transportation system, as well as a system to ensure that black balls will actually go into the goal, while the goals will never be exact same size. It is a pretty difficult task to design around.
But if you have a massive telescoping system to push balls in quickly, it is going to get you far into the finals. Because little points in the finals are going to matter a lot.


__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.