Thread: 45 degree PVC angle fittings: which?
View Single Post
  #2   Spotlight this post!  
Unread 23-06-2002, 22:53
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Re: 45 degree PVC angle fittings: which?
Posted by Mike Gray at 1/14/2001 8:10 AM EST


Engineer on team HOT from Huron Valley Schools sponsored by GM Milford Proving Ground.


In Reply to: 45 degree PVC angle fittings: which?
Posted by Joe Balint on 1/14/2001 1:05 AM EST:



The photo I took of the goal shows a "smooth" fitting. I can send a gif or jpg if you like.

Schedule 40 fittings don't have a neck, but drain PVC fittings do. Drain fittings also have a thin wall relative to schedule 40.

You will want schedule 40 fittings and pipe.


__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.