Thread: Bar Height
View Single Post
  #6   Spotlight this post!  
Unread 23-06-2002, 22:53
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
I am not seeing it...
Posted by Joe Johnson at 1/14/2001 1:45 PM EST


Engineer on team #47, Chief Delphi, from Pontiac Central High School and Delphi Automotive Systems.


In Reply to: Bar Height
Posted by Kailey on 1/14/2001 9:52 AM EST:



I am not seeing any label that says the bar is 18 inches.

Please tell me which print and in which "section" (I
use the term loosely as the views shown are not
sections at all).

I had to exstimate the height knowing the vertical bars
are 14.25" inches long (P16).

If this is true then it hardly seems possible that the
top of the bar is 18 because the 14.25" had to get the
3.5" of the "4X6" added to it plus the kee-klamp flange
plus the bar itself.

I guess the 18" is to the middle or perhaps the bottom
of the bar.

Let me know where I have screwed up if I am wrong.

Has anyone asked FIRST?

Joe J.



__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.