Thread: Bar Height
View Single Post
  #8   Spotlight this post!  
Unread 23-06-2002, 22:54
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
14-1/4" for P16 may not be right... check this out.
Posted by Andy Baker at 1/14/2001 11:26 PM EST


Engineer on team #45, TechnoKats, from Kokomo High School and Delphi Automotive Systems.


In Reply to: Re: Bar Height - 18" to top
Posted by Rick Gibbs on 1/14/2001 10:59 PM EST:



We found a problem with the "fence" today:

Sure, P16 is the vertical pipe on the "center barrier" or what our team calls the "fence". The BOM states that it is 14-1/4".

Now, look over at the perimeter of the field, where the vertical pipes are P8. P8 is stated to be 16" in the BOM.

Both of these vertical pipes sit on the same boards (B1 & B3, both 3.5" high), the same angled steel, and the same fittings (KK1-7).

With all of this in mind, P16 and P8 should be the same height... assuming two things:

1. The top edge of 16 is flush with the top of the fitting KK15-7.
2. The "fence" height is the same as the field border height... and they need to be since both fit into the fitting KK35-7.

Am I missing something here, of should P16 be 16" long?

Andy B.


__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.