Thread: Bar Height
View Single Post
  #9   Spotlight this post!  
Unread 23-06-2002, 22:54
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Where's the error?
Posted by Rick Gibbs at 1/14/2001 11:34 PM EST


Engineer on team #145, T-Rx, from Norwich High School, Sherburne-Earlville High School and Procter & Gamble Pharmaceuticals.


In Reply to: 14-1/4" for P16 may not be right... check this out.
Posted by Andy Baker on 1/14/2001 11:26 PM EST:



I had noticed that, too. So, I guess the height of the rail is all dependent upon where the error in the print is.

If it's 16" instead of 14-1/4", there's an extra couple inches of breathing room
__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.