Thread: Question about the bridge
View Single Post
  #11   Spotlight this post!  
Unread 23-06-2002, 22:54
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Re: V1.0 of the print had it wrong too!
Posted by Michael Betts at 1/15/2001 9:35 PM EST


Engineer on team #177, Bobcat Robotics, from South Windsor High School and International Fuel Cells.


In Reply to: V1.0 of the print had it wrong too!
Posted by Joe Johnson on 1/15/2001 8:44 PM EST:



: By the way, has anyone else found a secret dimension
: hidden on the print somewhere that tells where the "tow
: bars" are with respect to the edge of either the goal
: or the stretcher.

Dr, J,

From Update #3:

“The outer bolt holes of the grab bar mounts (Part # KK70-7) are in-line with the outer bolt holes of the caster bases. These holes fall approximately 1” in from the adjacent edge of the goal base.”

MIke


__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.