Thread: Module 7 gear -- fischer price motor
View Single Post
  #5   Spotlight this post!  
Unread 23-06-2002, 22:55
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Yes and no...
Posted by Joe Johnson at 1/14/2001 9:03 PM EST


Engineer on team #47, Chief Delphi, from Pontiac Central High School and Delphi Automotive Systems.


In Reply to: Can you buy both from Small Parts
Posted by Mark Garver on 1/14/2001 2:08 PM EST:



Small parts does sell some 32 DP gears as I recall.
They don't sell .7 module -- almost nobody does (my
only source is Pic-Design and they are not legal this
year).

We will be having a lot of gears cut from 1/4 steel
plate as this is an unlimited material per the
additional material list. One additional benefit to
having gears made from 1/4 steel is that the flavor of
the steel is not spelled out, this allows us to use
something with a bit more carbon in it than 1018, the
typical steel from Small Parts.

Good luck,

Joe J.



__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.