Thread: Parts converted to Autodesk Inventor
View Single Post
  #3   Spotlight this post!  
Unread 23-06-2002, 22:57
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Could you explain the process
Posted by Jason Rukes at 1/15/2001 1:51 PM EST


Engineer on team #109, Arial Systems & Libertyville HS, from Libertyville High School and Arial Systems Corp & SEC Design.


In Reply to: Parts converted to Autodesk Inventor
Posted by Steve Horst on 1/14/2001 9:25 PM EST:



Steve,

Would you mind explaining how you converted the parts to Inventor? We have a lot of parts on MD that we'd like to use on Inventor.

Thanks,
Jason


__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.