Thread: Bevel Gears on Drivetrain
View Single Post
  #1   Spotlight this post!  
Unread 23-06-2002, 22:57
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Bevel Gears on Drivetrain
Posted by Michael Quayle at 1/14/2001 10:57 PM EST


Engineer on team #253, MRT, from Mills High School.



We were considering using bevel gears on a drill motor, but the bevel gears sold by SmallParts are very small (in terms of the bore diameter). What are the advantages/disadvantages of using bevel gears on a drivetrain?
__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.