Thread: Bevel Gears on Drivetrain
View Single Post
  #5   Spotlight this post!  
Unread 23-06-2002, 22:57
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
I wouldn't use them but you can if you are careful
Posted by Joe Johnson at 1/15/2001 8:29 PM EST


Engineer on team #47, Chief Delphi, from Pontiac Central High School and Delphi Automotive Systems.


In Reply to: Bevel Gears on Drivetrain
Posted by Michael Quayle on 1/14/2001 10:57 PM EST:



Bevel gears are fantastic, if you know what you are
doing and you can spend time to get the interfaces right.

This is very ticklish business.

In general, I would never recommend a team try this
cold. If you have time in the off-season to work it
all out, go for it. In the heat of the 6 week build
without a trial run, I am not very optimistic of a good
outcome.

Just my opinion.

Joe J.



__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.