Couple of questions:
1) How do you have the motors wired? How are the connections going from the motor to the controller and from controller to the NXT?
2) What's the snippet of code that you have to drive the motors?
3) Have you tried just driving the NXT motors?
4) Are you using motor encoders (not that it should matter)?
5) Are you using ROBOTC 1.44? It was just updated and released early this week - see
www.robotc.net for details.
__________________
Mannie Lowe
FIRST Program Manager - Center for Mathematics and Science Education - University of Mississippi
Mississippi
FIRST Tech Challenge Affiliate Partner
