Thread: OVER THE BAR = #%? (not the bridge!)
View Single Post
  #7   Spotlight this post!  
Unread 23-06-2002, 23:02
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Re: getting over before it is all over...
Posted by Raul at 1/16/2001 8:48 PM EST


Engineer on team #111, Wildstang, from Rolling Meadows & Wheeling HS and Motorola.


In Reply to: getting over before it is all over...
Posted by Joe Johnson on 1/16/2001 8:33 PM EST:



Well I can think of one design that can "swim" and "skim" over the bar in less than 3 seconds. You just need the right software and a variation of the Aztec bot from '99. But it would take some extra motors to get over quickly which would not leave much for other functions.

What am I doing on this forum giving people Wild ideas? I should be doing some analysis or Stangthing!

Raul

: I can thinks a lots of ways to go over that bar, I will
: be honest I didn't much any of them

: I will be very impressed with robots that can get over
: the bar before the match is all over WHILE not leaving
: pieces of their robot all over.

: Hit the ground running!

: Joe J.





__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.