Thread: OVER THE BAR = #%? (not the bridge!)
View Single Post
  #12   Spotlight this post!  
Unread 23-06-2002, 23:02
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Re: OVER THE BAR = #%? (not the bridge!)
Posted by Ken Leung at 1/16/2001 1:39 PM EST


Student on team #192, Gunn Robotics Team, from Henry M. Gunn Senior High School.


In Reply to: OVER THE BAR = #%? (not the bridge!)
Posted by Anton Abaya on 1/16/2001 1:31 AM EST:



: As I asked who goes under, i know must ask who will hop the fence?

: i wonder...

: -anton abaya

It is actually quite easier to get over the bar then under, because that allows a much bigger space for the robot to go over. I can already see robot with tank treads able to raise the front of their base up there, and just ride right over the bar. And don't forget the pneumatics... one thick actuator can have 180 lbs of force comming out of it, imagine a robot with two of those hopping over the bar. A large arm can also flip a robot over those bars... plus many other ways.

As for T190's spider robot, I can't wait to see it in action.
__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.