Thread: Material for Operator Interface
View Single Post
  #2   Spotlight this post!  
Unread 23-06-2002, 23:03
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Re: Material for Operator Interface
Posted by Matt Leese at 1/16/2001 1:23 PM EST


Other on team #73, Tigerbolt, from Edison Technical HS and Alstom & Rochester Institute of Technology.


In Reply to: Material for Operator Interface
Posted by Matt Berube on 1/16/2001 1:09 PM EST:



That question was asked in one of the Team Updates. I believe it was Update 3 if I'm not mistaken. The answer (and this is off the top of my head so it might not be quite right) was that you can use what ever you like for mounting purposes but any electrical part of the OI has to be from the additonal hardware list, etc.

Matt
__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.