Thread: The bridge ... moves?
View Single Post
  #3   Spotlight this post!  
Unread 23-06-2002, 23:04
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Re: The bridge ... moves?
Posted by colleen -- T190 at 1/16/2001 8:57 PM EST


Engineer on team #190, Gompei, from Massachusetts Academy of Math and Science and WPI.


In Reply to: The bridge ... moves?
Posted by Jake on 1/16/2001 7:48 PM EST:



Ours doesn't move either.. and we've been playing on it with last years robots and walking back and forth, etc...

I would double check the width between your pivot brackets (we have 6-7/16" from outside to outside side of the angle iron bracket).. and ensure that you have the correct thickness angle on the piece of wood (which runs along the floor and the bridge sits on).. and also that you have the small angle on that board that sticks up on each side to keep the bridge from moving side to side (since it should only move up and down)..

that's my only advice.. double.. triple.. quadruple check the prints.. ours was a bit screwed up until the Assabet folks helped steered us to the right dimensions and etc..


__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.