Thread: The bridge ... moves?
View Single Post
  #4   Spotlight this post!  
Unread 23-06-2002, 23:04
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Re: The bridge ... moves?
Posted by ChrisH at 1/17/2001 11:16 AM EST


Engineer on team #330, Beach 'Bots, from Hope Chapel Academy and NASA JPL, J & F Machine, Raetheon, et al.


In Reply to: Re: The bridge ... moves?
Posted by colleen -- T190 on 1/16/2001 8:57 PM EST:




: that's my only advice.. double.. triple.. quadruple check the prints.. ours was a bit screwed up until the Assabet folks helped steered us to the right dimensions and etc..

Would one of you be willing to post this information? our bridge is still under construction and it would be helpful not to have to do it over.

Chris Husmann, PE
Team 330 the Beach'Bots


__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.