Thread: Can I drill the output shafts of unmodifiable motors?
View Single Post
  #1   Spotlight this post!  
Unread 23-06-2002, 23:08
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Can I drill the output shafts of unmodifiable motors?
Posted by CArobot at 1/17/2001 7:39 PM EST


Other on team #619, CArobot, from Charlottesville Albemarle.



Can I drill the output shfts of unmodifiable motor, as in for a pin or screw?


__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.