Thread: Can I drill the output shafts of unmodifiable motors?
View Single Post
  #5   Spotlight this post!  
Unread 23-06-2002, 23:08
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Yes, If You Dare!
Posted by ChrisH at 1/18/2001 1:48 PM EST


Engineer on team #330, Beach 'Bots, from Hope Chapel Academy and NASA JPL, J & F Machine, Raetheon, et al.


In Reply to: Can I drill the output shafts of unmodifiable motors?
Posted by CArobot on 1/17/2001 7:39 PM EST:



: Can I drill the output shfts of unmodifiable motor, as in for a pin or screw?

Our team's policy is NOT to modify a motor in any way we can't repeat as a field repair. It's just too hard to replace a fried motor. We've never managed to need this ourselves, but we've learned fronm the painful experience of others.

In love with IR&R (Interchangeable Remove and Replace) Motors

Chris Husmann, PE
Team 330 the Beach'Bots



__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.