Thread: good idea or bad?
View Single Post
  #3   Spotlight this post!  
Unread 23-06-2002, 23:08
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Re: good idea or bad?
Posted by CArobot at 1/17/2001 9:02 PM EST


Other on team #619, CArobot, from Charlottesville Albemarle.


In Reply to: good idea or bad?
Posted by Rob DeCotiis on 1/17/2001 8:10 PM EST:



: is it a good or bad idea:
: if you're tight on weight, just drilling holes in all of your stuff so it doesn't weight as much, suck as drilling holes in the claw that picks up the balls, or something like that?(just in preparation... )

this totally depends on your individual robot. If you built your structure out of 1/16" aluminum and it has some structural funtion I wouldn't drill it. If it's not structural or has a lot of built in overkill in regard to strength-drill away.
__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.