Thread: Can I use any type of switch on my controler interface?
View Single Post
  #4   Spotlight this post!  
Unread 23-06-2002, 23:09
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Re: no lighted switches...
Posted by Matt Leese at 1/17/2001 10:37 PM EST


Other on team #73, Tigerbolt, from Edison Technical HS and Alstom & Rochester Institute of Technology.


In Reply to: Re: no lighted switches...
Posted by Brian on 1/17/2001 10:07 PM EST:



And satisfaction brought it back. But seriously, I believe they don't allow lighted switches because of the way power is fed from the Operator Interface. First of all, if the power draw is too great then the OI might assume that the switch is tripped when it's not. The other reasoning would be that they don't allow other lights so why would they allow lights on switches.

Matt


__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.