Thread: POST YOUR DRILL GEAR RATIO ....... HERE.......
View Single Post
  #3   Spotlight this post!  
Unread 23-06-2002, 23:09
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Trade secrets...
Posted by Joe Johnson at 1/18/2001 10:27 PM EST


Engineer on team #47, Chief Delphi, from Pontiac Central High School and Delphi Automotive Systems.


In Reply to: Reost: POST YOUR DRILL GEAR RATIO ....... HERE.......
Posted by Anton Abaya on 1/18/2001 7:45 PM EST:



Anton,

We consider this to be a trade secret. We give teams
very general advice if they ask about how fast a robot
should go, but the exact ratio, no, we don't share this
information.

While we are all for cooperation, we are also looking
for small edges here and there.

This is one of them.

Are we out of the mainstream in this or do other teams
have similar information they consider important that
they keep to themselves?

Do tell.

Joe J.



__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.