Thread: POST YOUR DRILL GEAR RATIO ....... HERE.......
View Single Post
  #5   Spotlight this post!  
Unread 23-06-2002, 23:09
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Secret's Out
Posted by Dodd Stacy at 1/19/2001 10:59 AM EST


Engineer on team #95, Lebanon Robotics Team, from Lebanon High School and CRREL/CREARE.


In Reply to: Re: Trade secrets...
Posted by Michael Betts on 1/19/2001 10:47 AM EST:



: : Are we out of the mainstream in this or do other teams
: : have similar information they consider important that
: : they keep to themselves?

: : Do tell.

: : Joe J.

: Dr. J,

: I agree, every team should have a few trade secrets that distinguish them from other teams.

: This is, after all, a competition.

: Mike

Uhhh. We vary the gearing between 1 and 10 ft/sec and let our drivers practise until they minimize their gymkhana (sp?) time. And of course they're practising right now! How about your team?

Dodd



__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.