Thread: Pneumatics electrical wiring and programming
View Single Post
  #1   Spotlight this post!  
Unread 23-06-2002, 23:10
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Pneumatics electrical wiring and programming
Posted by Dan Grostick at 1/18/2001 10:08 AM EST


Engineer on team #267, Demolition Squad, from North Broward Prep / St. Andrews.



I've posted information (in the White Papers section) on the electrical wiring and programming of the pneumatics subsystem. I want to share my experiences programming the pneumatics demo board shown at the First kickoff.

Dan Grostick (267)


__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.