Thread: Pneumatics electrical wiring and programming
View Single Post
  #2   Spotlight this post!  
Unread 23-06-2002, 23:10
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Comment out the relay line in default program
Posted by Vince Wilczynski at 1/20/2001 8:15 PM EST


Engineer on team #124, Whalers, from New London / Montville/ Williams School and Notheast Utilities / US Coast Guard Academy.


In Reply to: Pneumatics electrical wiring and programming
Posted by Dan Grostick on 1/18/2001 10:08 AM EST:



Thanks Dan.
One note, make sure you comment out the relay5 lines in the default program as noted below:
'relay5_fwd = p1_sw_aux1 'Port 1 Aux1 = Relay 5 Forward
'relay5_rev = p1_sw_aux2 'Port 1 Aux2 = Relay 5 Forward
/


__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.