Thread: Wiring the actuator
View Single Post
  #2   Spotlight this post!  
Unread 23-06-2002, 23:11
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Re: Wiring the actuator
Posted by Ed Sparks at 1/18/2001 9:06 PM EST


Coach on team #34, The Rockets, from Bob Jones High / New Century High and DaimlerChrysler.


In Reply to: Wiring the actuator
Posted by Patrick Dingle on 1/18/2001 3:42 PM EST:



Use a servo cable. The female end of the cable fits the connector on the Belimo motor just fine. Cut the male end off, strip the wire and connect to the appropriate output device (spike or victor). Note that the motor only requires two of the three conductors.


__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.