Thread: Wiring the actuator
View Single Post
  #6   Spotlight this post!  
Unread 23-06-2002, 23:11
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Re: Wiring the actuator
Posted by Dan Grostick at 1/22/2001 9:44 AM EST


Engineer on team #267, Demolition Squad, from North Broward Prep / St. Andrews.


In Reply to: Wiring the actuator
Posted by Patrick Dingle on 1/18/2001 3:42 PM EST:





For prototyping purposes, an inexpensive way is to use a modified integrated circuit socket - just cut off the extra positions. These are available at Radio Shack.


__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.