[dnhansen]

I'm using Labview 8.5.1 to try and run motors and a servo. I can run the motors alone or the servo alone, but when I combine the two, the motors buzz and the controllers are unresponsive. I started with the program from the FTC tutorial, but it didn't work. I've also tried several other configurations, hardware and software, but always the same result... buzzing motors and no response from the controllers. The only configuration in which I could get a servo to work is when I plugged the servo controller directly into the NXT instead of the motor controller. Any ideas?

Also, is there anyway to run the servo with a button?