Thread: Sensor use on Papst Large Fan
View Single Post
  #7   Spotlight this post!  
Unread 23-06-2002, 23:14
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Re: Sensor use on Papst Large Fan
Posted by Michael Betts at 1/21/2001 10:47 AM EST


Engineer on team #177, Bobcat Robotics, from South Windsor High School and International Fuel Cells.


In Reply to: Re: Sensor use on Papst Large Fan
Posted by Joe Balint on 1/20/2001 11:06 AM EST:



Joe, et al,

The RPM signal will probably not be of much use as the RPM of the fan is pretty high and the update time of our CPU is pretty low.

If you need an RPM sensor, a better tack is to use the optical sensor with a small "flag" attached to the shaft in question.

Mike



__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.