Thread: Interchangable Motors?
View Single Post
  #2   Spotlight this post!  
Unread 23-06-2002, 23:14
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Re: Interchangable Motors?
Posted by Matt Berube at 1/19/2001 7:44 AM EST


Engineer on team #49, Delphi Knights, from Buena Vista High School and Delphi Automotive.


In Reply to: Interchangable Motors?
Posted by rebecca on 1/19/2001 3:21 AM EST:



: back in the "can i drill a hole in a motor shaft" thread, a few people mentioned having complete interchangability pertaining to motors. What kind of system allows that? set screws?
: what we've done is have a keyway w/ key and keep a spare modified motor on hand. If we burn that spare too, we are screwed. But we've never even needed the one spare so...

: Is there is a better way?

In the past we have used the 2 flats on the van door and globe motors to turn a modified gear/sprocket.

Matt B.
T49


__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.