Thread: Goal Bolt Lengths
View Single Post
  #1   Spotlight this post!  
Unread 23-06-2002, 23:14
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Goal Bolt Lengths
Posted by Dodd Stacy at 1/19/2001 10:51 AM EST


Engineer on team #95, Lebanon Robotics Team, from Lebanon High School and CRREL/CREARE.



Does anyone have information on whether the 1/4-20 x 1 1/2 inch carriage bolts (BO7) attaching the casters and Kee Klamp flanges to the goal bases are intended to go head up or head down? We first assumed head up and installed them so, but they stuck out so far on the bottom they interfered with caster rotation.

They also made the bottom surface of the goal pretty ugly for reaching under with a picker-upper mechanism. So we inverted the bolts to head down and let the excess length stick up. We want to get a correct definition of the goal underside neighborhood before groping around under there developing lifting hardware.

Does anybody else have input on this? Thanks.

Dodd


__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.